The linear vibrating screen just bought is used for the first time. As long as you pay attention to the following operations, the linear vibrating screen can make an ideal screening for materials. 1. Adjustment of excitation force: We all know that the exciting force affects the screening efficiency and output of materials, so it is very important to adjust the exciting force of linear vibrating screen. The exciting force of the vibration motor can be adjusted by adjusting the eccentric blocks at both ends of the vibration motor. 2. Connection of lines: Under normal circumstances, the linear vibrating screen has reserved the outlet for wiring in the workshop. According to the operation steps in the "Motor Circuit Connection of the Operating Instructions for Linear Vibrating Screen", when the vibrating motor is installed on the screen box, the eccentric blocks at both ends of the vibrating motor are installed at a certain angle instead of in the same direction, and the motor structures on the left and right sides are just opposite. It is worth noting that the mating surface of the connection port thread and the motor junction box must be coated with sealant to prevent water from entering during the screening process. 3. Addition of lubricating oil: After the linear vibrating screen works for 2 months, all bearings should be lubricated. When adding lubricating oil, be careful not to add too much, because too much will make the vibrating motor winding and affect the coil heating. 4, screen installation: Usually, the screen of linear vibrating screen is installed, and it is not necessary to operate it again, but the replacement of the screen is also an operation that often needs to be done after the later work. Therefore, it is very necessary to learn to install the screen. The screen installation steps of linear vibrating screen are very simple, only two steps are needed: 1) Loosen the tension bolt for fastening the screen. It is not necessary to completely remove the nut. Just rotate it by 90 degrees to make it exit from the long hole of the screen hook plate and take out the screen. 2) put on a new screen, tension the screen so that the left hook plate is in a vertical position, tension the right hook plate of the screen, then tighten the left side and tighten the bolts.

  Relevant